Insulated Cooler
In Stock
Insulated cooler for hauling groceries and beverages with our quick Connect+ system for easy installation and removal.
ONLY compatible with CONNECT+ system rear racks.
NOT compatible with CONNECT+ front rack.
Thirty (30) lbs weight capacity.
Dimensions: 7.5” wide x 14” long x 8” tall
This cooler is compatible with any model that advertises the Connect+ system. It will connect to the following bike/accessories:
- Vorsa (directly to integrated rear rack)
- Cafe Cruiser (directly to integrated rear rack)
- Portola (directly to integrated rear rack)
- 700 Series (rear rack with Connect+ logo only)
- Prodigy v2 (directly to included rear rack) *do not exceed the rack’s 40 lb limit*
- Rift (directly to integrated rear rack)
- Revv 1 Connect+ Rear Rack and Handle
- Ride1Up Rear Rack (separate purchase – ONLY fits CF Racer1, Core-5, Turris, LMT’D and LMT’D V2)
- Roadster v3 Connect+ Rear Rack (separate purchase)
-
Assembly & InstallationAccessory goes great with
Reviews
| 5 star | 60% | |
| 4 star | 20% | |
| 3 star | 16% | |
| 2 star | 4% | |
| 1 star | 0% |
1-6 of 25 reviews
High-quality. Easy to install.
love it
One screw will not screw into the Connect+ latch to cooler. Difficultly attaching to bike rack and removal of cooler. Like it!
works great as cooler and storage as well. 🙂
A little tough to install and screws are almost too short. Works well though as both an insulation bag and a general carry bag. I picked up food on it the other day and it was still warm when I got home.
While the cooler worked as intended but the hardware is a different story. The bolts that were supplied barely made contact with the preset locations so when you go to attach the cooler it is barely holding on and any slight bump will knock it off or when you lock it in they will slip out. Just need the screws to be atleast 1/8” longer
Hi James, we have recently expanded our instructions. The screws would press through the cooler if they are longer. What works well, if you open the cooler and push down from the top, while threading the bolts on the other side, it will hold the internal nuts in place, allowing it to thread fully/properly.